The Brinell hardness of a rolling force sensor is 360-400 degrees. The general rectangular sensor has 8 groups of holes and 12 groups of holes. The resistance value in the hole is determined by the number of strain gauges. Each piece is 120 ohm (Ω). Output line is generally red and white insulation value General requirements New products not less than 500 megohm (MΩ) Use requirements not less than 20 megohm (MΩ)

·  Repeatability error ± 0.1%FS

·  Nonlinear error ± 0.5%FS

·  Lag error ± 0.3%FS

·  Sensitivity is 1.2mv/v ~ 1.8mv /v

·  The operating temperature is -20℃ ~ 150℃

·  Overload capacity 150% without zero drift

·  The bridge voltage of the sensor is 10V

·  Output can be 0 ~ 10V; 0 ~ 20mA; 4 ~ 20m

·  The upper and lower pressure balancing pad of the sensor and the upper and lower surface of the sensor, the flatness and parallelism should be within 0.02mm, the surface finish must beRa≤0.06, the upper and lower surface of the sensor and the upper and lower surface in contact with it should use molybdenum disulsulfide anti-wear solution